杨朔, 戴广龙, 唐明云. 基于程序升温的煤自燃标志气体实验研究[J]. 煤矿安全, 2018, 49(7): 24-27,33.
    引用本文: 杨朔, 戴广龙, 唐明云. 基于程序升温的煤自燃标志气体实验研究[J]. 煤矿安全, 2018, 49(7): 24-27,33.
    YANG Shuo, DAI Guanglong, TANG Mingyun. Experiment Study on Mark Gas of Coal Spontaneous Combustion Based on Programmed Temperature Program[J]. Safety in Coal Mines, 2018, 49(7): 24-27,33.
    Citation: YANG Shuo, DAI Guanglong, TANG Mingyun. Experiment Study on Mark Gas of Coal Spontaneous Combustion Based on Programmed Temperature Program[J]. Safety in Coal Mines, 2018, 49(7): 24-27,33.

    基于程序升温的煤自燃标志气体实验研究

    Experiment Study on Mark Gas of Coal Spontaneous Combustion Based on Programmed Temperature Program

    • 摘要: 为有效解决袁店二井煤矿72煤层自燃问题,对煤样进行程序升温实验研究煤自燃标志气体,通过分析煤氧化过程中不同温度阶段气体产生规律,研究煤自燃预测预报标志气体与其之间的对应关系。结果表明:实验煤样的自热临界温度为60~70 ℃,氧化活跃阶段临界温度为120~130 ℃,在60~100 ℃时,选取CO作为标志气体,在100~130 ℃时,选取第二火灾系数R2作为标志气体,在130 ℃以上时,选取C2H4作为标志气体,以C2H6、链烷比φ(C3H8)/φ(C2H6) 和烯烷比作为辅助标志气体,以此可判断该煤层煤自燃发展程度。

       

      Abstract: In order to solve coal spontaneous combustion problem of 72 seam in Yuandian Mine effectively, the mark gas of spontaneous combustion was studied by temperature programming experiments on coal samples. By analyzing the gas generation laws at different temperature stages in coal oxidation process, the corresponding relationship between mark gas of coal spontaneous combustion and temperature is researched. The results show that the critical temperature of coal self-heating is 60 ℃ to 70 ℃ and the critical temperature of oxidation active stage is 120 ℃ to 130 ℃. Hence, CO was selected as the mark gas at 60 ℃ to 100 ℃ and the second fire index R2 was selected as the mark gas at 100 ℃ to 130 ℃. When the temperature was over 130 ℃, C2H4 was selected to be the mark gas and C2H6, alkane ratio φ(C3H8)/φ(C2H6) aand alkene-alkyl ratio are used as the auxiliary mark gas to determine the degree of spontaneous combustion of coal seam.

       

    /

    返回文章
    返回